How To:


Avet Reel Cliker Upgrade


Author: Christopher Meza


Made a simple video on how you can remove the springs off your clicker and make your avet clicker louder by this simple modification. might not be the best tutorial video I created but its really simple to do and the way I decide to remove the spring was by opening one end of the spring completely, then the other spring, I push out with a small screw driver. 

once removed, then you can cut springs in half and then the end that was opened completely, will need to be bent into a loop so that when we put the springs back it will hold in place. another option is to remove the c clip and that allows you to remove the entire clicker mechanism. once completely removed then it should be a lot easier to modify the springs. if you follow the video you will see that its not very completed at all and anyone can do this simple modification.


The reason I decide to try this is because I felt my avet clicker wasnâ??t loud enough and if we shortened the springs in half then we would increase the tension needed for the spool to spin when a fish takes our bait. When the tension is increased, clicker becomes louder and a lot less loose when set in bait position. i noticed a big difference after i shortened the springs and i compare how it sounds before and after in the video. leave a comment below on the youtube video if you think it made a difference for your reel!

If this video helps, Subscribe and thumbs up the video! 

#1kSubs #Subscribe #TxFinChasers  


We Help Millions Of Anglers Spend More Time Fishing

We hope that you enjoyed this article on the Bullbuster Community.  It is our mission to help millions of anglers spend more time fishing and that starts with YOU!

Tour Our Factory Below


Buy Your Fishing Line Brand Direct Online Now!

Back